Vodavi Starplus STSe, Quick Start Manual

Page: 49 / 72

STSe Quick Start Guide September 2005
- 45 -
VO D AVI
WIN DBA (cont’d)
7. Select “Ports”. (See Programming Manual, Section F, Flash 42 & 52 for programming information.)
a. Program as required. Note under most cases, do not make any changes in this section. Keeping it
simple is the best. If you change a port around and then went to work on CO Line 1 and now it was on
Port 24 it would be confusing. Correct?
b. Click Save and “X” to exit.
8. Select “Stations”. (See Programming Manual, Section F, Flash 50 for programming information.)
a. Note folders (Stations, Features, Buttons, Speed, Volume, Preset Fwd, Grid, Copy, and report)
b. Use the > < keys to move from station to station.
c. Note Copy allows you to copy from one station to three block of a group of station numbers to include
copying buttons “Yes or No”.
d. The Button Folder is like the Card slot programming. First select either Button number or Type. Then
select feature under Type block. Then click button to make change.
e. When completed, save and click on “X” to exit.
9. Select “System Features”. (See Programming Manual, Section F, Flash 01, 02, 05, 06, 07, 09, 10, 11, 12,
13, 14, 15, 20, 21, 22, 23, 39, and 52 for programming information.)
a. Note the “Flexible Numbering Plan”. Remember, if changes are made here make sure it does not
conflict with some other code, the user guide and you must be able to maintain these changes.
b. When completed, save and click on “X” to exit.
10. Select “Toll Restriction Programming”. (See Programming Manual, Section F, Flash 70, and Flash 50 Page
B Flex buttons 2 and 3 for programming information.)
a. Note three folders (Allow/Deny Table A, Allow/Deny Table B, and Special Tables)
b. If a Station is in Class of Service (COS) 2, 3 or 4, the system would go check Toll restrictions Table A
Allow. If found call would be allowed. If no found in the Allow it would go to the Denied Table. If found
in the Deny Table call is Denied. If not found in either table call is allowed.
c. Program as required.
d. When finished, save and click on “X” to exit.
11. Select “T1”. (See Programming Manual, Section F, Flash 47 for programming information.)
a. Program as required
b. When finished save and click “X” to exit.
12. Select “UCD”. (See Programming Manual, Section F, Flash 60, 61 and 62 for programming information.)
a. Program as required
b. When finished save and click “X” to exit.
13. Select “Voice Mail Programming”. (See Programming Manual, Section F, Flash 65, 66, and 76 for
programming information.)
a. No programming is required if you are using the STSe In-Skin Voicemail system.
b. If you are using the Dispatch Voicemail system only the station members need to be changed to
stations connected to the Dispatch.
c. When completed save and click “X” to exit.