Vimar Elvox 46235.030D, Installation And Operation Manual, Page: 44 / 70

44
Graphic User Interface (GUI) for IP Speed Dome
EN
Note : To save images to the local PC, please enable the local smart snapshot storage first (Config System
Local Config). To save images to the SD card, please install an SD card and enable “Trigger Snap” first.
3. Set alarm holding time and alarm trigger options.
4. Set alarm detection area. Click “Draw Area” and drag the border lines of the rectangle to modify its size. Move the
rectangle to change its position. Click “Stop Draw” to stop drawing the area. Click “Clear” to clear the area. Then set
the detectable face size by defining the maximum value and the minimum value (The default size range of a single face
image occupies from 3% to 50% of the entire image).
5. Face database management: click “Face Database Management” tab. This will enter the following interface.
There are four ways to add face pictures.
(1) Adding face pictures one by one
Click
to pop up an adding user box. Then click to select a face picture saved on the local PC. Please select
the picture according to the specified format and size limit. After that, fill out the relevant information of the face picture
and click “Entry” to add.
(2) Adding multiple face pictures at a time
Click
and then add multiple face pictures once according to the prompted rules.
(3) Add face pictures by using face album management tool
(4) Add the captured picture in the live mode (See Add captured face pictures to the face database ).
After adding face pictures, you can search them by name, gender, ID number and so on.