Vimar Elvox 46235.030D, Installation And Operation Manual, Page: 41 / 70

41
Graphic User Interface (GUI) for IP Speed Dome
EN
2. Set the alarm area number on the right side. Up to 4 alarm areas can be added.
3. Set the detection area by clicking the buttons of area (1) and then click “Lock” to lock the area.
Note : The PTZ will not be controlled if you click “Lock” here. Click “Unlock” and then click the buttons of area ① to
move the PTZ camera. Clicking the “Unlock” button suspends object tracking until you click the “Lock” button.
4. Click the “Draw Area” button and then click around the area where you want to set as the alarm area in the im-
age on the left side (the alarm area should be a closed area). Click the “Stop Draw” button to stop drawing. Click the
“Clear” button to delete the alarm area. Click the “Save” button to save the settings.
After that, the camera will automatically return to this detection area after auto human /vehicle tracking.
- Schedule Configuration
Set the schedule of the intrusion detection. The setup steps of the schedule are the same as schedule recording
setup (See Schedule Recording).
5.4.8 Region Entrance
Region Entrance : Alarms will be triggered if the target enters the pre-defined areas.
Go to Config Event Region Entrance interface as shown below.
1. Enable region entrance detection and select the snapshot type and the detection target.
2. Set the alarm holding time.
3. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to motion detection chapter
for details.
4. Set the alarm area of the region entrance detection.