Vimar Elvox 46235.030D, Installation And Operation Manual, Page: 30 / 70

30
Graphic User Interface (GUI) for IP Speed Dome
EN
5.2.3 OSD Configuration
Go to Image OSD interface as shown below.
Set time stamp, device name, device status language, OSD content and picture overlap here. After enabling the
corresponding display and entering the content, drag them to change their position. Then click “Save” to save the
settings.
Show Azimuth: Show the PTZ moving direction on the live view interface.
Show Run Status: Show the PTZ control status on the live view interface. For example, if the preset 2 is called,
“PRE:002” will be shown on the live view interface.
Picture Overlap Settings:
Check “OSD Content1”, choose “Picture Overlay” and click “Browse” to select the overlap picture. Then click “Upload”
to upload the overlap picture. The pixel of the image shall not exceed 200*200, or it cannot be uploaded.
5.2.4 Video Mask
Go to Image Video Mask interface as shown below. A maximum of 4 zones can be set up.
Only some models support this function. If your PTZ camera doesn’t support it, please skip the following instructions.
To set up video mask:
1. Enable video mask.
2. Click direction buttons to change the area you want to mask.
3. Click “Draw Area” and then drag the mouse to draw the video mask area.
4. Click “Add” to add the mask area.
To delete mask area:
1. Select the mask area in the mask area list.
2. Click “Delete” to delete this mask area.