Vimar Elvox 46235.030D, Installation And Operation Manual, Page: 39 / 70

39
Graphic User Interface (GUI) for IP Speed Dome
EN
5.4.6 Line Crossing Detection
Line Crossing : Alarms will be triggered if the target crosses the pre-defined alarm lines.
Go to Config Event Line Crossing interface as shown below.
- Detection Configuration :
1. Enable line crossing detection and select the snapshot type and the detection target.
Save Panoramic Picture : If it is enabled, the detected panoramic pictures will be captured and saved to the SD card
when the targets cross the alarm line.
Save Target Cutout : If it is enabled, the detected target cutout pictures will be captured and saved to the SD card
when the targets cross the alarm line.
Note : To save snapshots to the local PC, please enable “Local Smart Snapshot Storage” in the local config interface
first. To save snapshots to the SD card, please install an SD card first.
Detection Target :
Human: Select it and then alarms will be triggered if someone crosses the pre-defined alarm lines.
Motor Vehicle : Select it and then alarms will be triggered if a vehicle with four or more wheels (eg. a car, bus or
truck) crosses the pre-defined alarm lines.
Motorcycle/Bicycle : Select it and then alarms will be triggered if a non-motor vehicle (eg. a motorcycle or bicycle)
crosses the pre-defined alarm lines.
The three types of objects can be selected simultaneously. Please select the detection objects as needed. If no
object/target is selected, alarms will not be triggered even if line crossing detection is enabled.
2. Set the alarm holding time.
3. Set alarm trigger options.
Alarm Out: If selected, this would trigger an external relay output that is connected to the camera on detecting a
target crossing the alarm line.
Trigger Track : if enabled, the PTZ camera will automatically track the target that crosses the alarm line and the
target’s image will be automatically zoomed in and centered on the screen until the target disappears on the screen.
After that, the PTZ camera will return to the pre-defined detection area.
Trigger SD Snap: If selected, the system will capture images when a target crosses the alarm line and save the
images on an SD card.
Trigger SD Recording: If selected, video will be recorded on an SD card when a target crosses the alarm line
Trigger Email : If “Trigger Email” and “Attach Picture” are checked (email address must be set first in the Email con-
figuration interface), the captured pictures and triggered event will be sent into those addresses.
Trigger FTP : If “Trigger FTP” is checked, the captured pictures will be sent into FTP server address. Please refer to
FTP configuration chapter for more details.
4. Click “Save” button to save the settings.
- Area Configuration
1. Click the “Area and Sensitivity” tab to go to the interface as shown below.