4. End of installation
You have recorded and fix all the devices, record the remote controls, then with the question :
Display of the keypad
Actions and commentaries
ENTERING A NEW
DEVICE ?
OPERATION
COMPLETED ?
SYSTEM CHECK
IN PROGRESS
INSTALATION
SUCCESSFUL !
(Close the cover of the panel)
All that remains is to program the user
codes, Partial arming modes and eventually
the Intercom time (at 180 seconds).
5. How to...
5.1 Go back to the inactive state of the keypad
To return to the inactive state menu state, press 5 seconds on
the key .
5.2 Change to installer level 4)
With direction arrows
go to the menu
ACCESS LEVEL
.
Validate with the [YES] key.
Appear
LEVEL : 1
or
LEVEL : 2
or
LEVEL : 3
Wiith the direction arrow chose level 4 and validate witht the
[YES] key, + installer code + [YES] key.
In level 4 (installer level), an additional menu appears: the menu
CONFIGURATION
(helps to add, delete and configure the devices,
partials, prefix…)
5.3 Add a user code
For security reasons, no user code is recorded. It is then
necessary for once installation is finished, to create one.
With arrow directions
go to the menu
BADGES / ACCESS CODE
+ [YES]. Enter the usercode
+ [YES]. Again [YES] to record a new code. Enter the code.
Validate it by recording, then name it.
Each recorded code is in level 3 by default. From this moment
on, the user code created can in turn can record other user code.
It is possible to record up to 19 user codes.
5.4 Modify a level of a user code
Code level 1 : enable arming/disarming eand partials.
Code level 3 : equal to level 1 + creation/modification of codes,
reader of the event journal and date and hour modification.
With direction arrows
go to the menu
BADGES / ACCESS CODES
.
Enter a valid code (minimum level 3).
With direction arrows, go to the menu
BADGES / CODES
CONFIGURATION.
Validate with the [YES] key. Select the code to be modified.
With the direction arrows go to the menu :
ACCESS LEVEL 3
.
Validate with the [YES] key. With the direction arrows, modify
the level revalidate with the [YES] key.
5.5 Program the arming modes profiles
With direction arrows
go to the menu
CONFIGURATION
(level 4 + installer code + [YES]) ->
ALARM
MODES PROGRAMMABLE
->
FULLY ARMED, MODE SP1,
MODE SP2
(use the direction arrows: right or left and [YES] to
select the alarm mode to be modified).
A first screen will confirm the concerned areas by this mode.
Each time you press on N° of the concerned area, modifies
the state of the correspondant situated below (validation by the
[YES]) key. Then select the alert type sound you want with the
direction arrow (Cf. diagram in the following page).
