I N S T A L L A T I O N D A T A S H E E T - P R O G R A M M I N G
New functionalities
5
www.videofied.com
5.3 Arming by the badge reader
After arming of the master (total mode only) by using a badge on
a badge readers, when crossing the badge, the reader emits a
beep then two showing its acceptance of the arming command.
The indicators of the reader remain on for 5 seconds, as shown
in the diagram below.
However, if a (non temporized) contact remained open, in
less than 2 seconds the two indicators changes to green for 5
seconds, then goes off, which indicates that you have to verify
which contact is open and in which area.
The menus displayed on the keypad are :
6 Supply of the panel with 12V (panel
without interphone only)
All the (that do not manage the interphone) panels have the
uniqueness of been supplied by 12 volts direct current 2,2 amps.
See diagram below for wiring.
Thus, there is no need for power supply with batteries or even
batteries from the panel can be presented and used as back up in
case of power failure from the mains.
7. Management of power failures from the
mains (panel without interphone only)
All the (that do not manage the interphone) panel have the
uniqueness of managing the power failure from the mains.
The panel must imperatively be supplied by usual batteries
LSH20, in order to guarantee its autonomy.
When the 2 beeps
(confirmation of
arming)
The indicator at
the top flashes red
during arming time
If a contact remained
open, the indicators
remains fixed green for 5
seconds.
DETECTION
Area_n, Name_Device
ESC = BYPASS DEV.
YES = TRY AGAIN
The keypad emits a beep every
8 seconds and alternatevelly
displays the detection area for
4 seconds as well as the name
of the device concerned and
for 4 seconds, it displays the
possibility of ejecting the device
or retry rearming after having
closed the contact concered.
The user has 3 minutes to make
his/her choice, and exceeding
this time the panel forces the arm
by ejecting the open device.
}
12V 2,2A
Power (+12V)
GND (0V)
