5. How to...
5.13 How to activate/deactivate the monitor
station?
With direction arrows go to the menu
CONFIGURATION
(level 4 + installer code + [YES]) ->
CONFIGURATION MONITOR. STATION
->
MONITORING
PARAMETERS
->
MONITORING ?
Press on the key
, then select the state that you want (active
or inactive) with the direction arrows
and finally validate with the key
.
6. Details of the menu : ALARM CODES /
TRANS STATE MODIFICATION
6.1 Signalling events by default (except if you are
using pre programming)
By default these events are transmited:
DEVICE
(intrusions)
ALERT
(button)
TAMPER
PERIODIC TEST
By default are not transmited:
INITIALIZATION
PANEL BATTERIES
(low panel batteries)
AC POWER
(panel power off)
PHONELINE FAULT
(telephone)
DEVICE BATT.
(low batteries devices)
RADIO JAMMING
(radio jamming)
SUPERVISION
(default supervision)
WRONG CODES
(when entering 5 false codes/badges)
DURESS CODE
(panic button)
ALARM MEMORY (
old memory overwritten)
ARM/DISARM
(open/close)
There are the 3 transmission
states:
ALARM
, which can be heard :
when it appears
ALARM / END,
which can be
heard : when it appears and disap-
pears
NOT TRANSMITTED
Examples :
- If one wishes to recall events of
ARMING/DISARMING
(operate/stop), you will have to modify the
configuration of events
ARMING/DISARMING
to
ALARM / END
.
- If you wish to recall the false codes information, you will have to modify the configuration of events
WRONG CODES
on the state
ALARM
.
