Victoria CLASSIC 40C, Instruction Manual

Page: 14 / 32

05.2020 INSTRUCTION MANUAL for installation and operation of pellet boiler CLASSIC 40C
14
Important Features:
- the minimum possible temperature that can be set is 55 ° C;
- the maximum possible temperature that can be set is 80 ° C.
Entering the temperature is done through the Left and / or Right icons. Saving the value is
done with the Button .
Pressing the button displays a green ribbon low down, which one should wait to fill up, and
then it would disappear, in this case one can sure that the value has been saved correctly!
Just in case, during the time of saving, access to the Back Icon is denied to prevent
involuntary interruption of the save process. The latter would reappear after the process
has finished.
Manual
Fuel.
pressing the icon would start the screw conveyor for 10 seconds! When this time is over,
the screw conveyor stops again and waits until a new icon click is done.
The icon would only be visible in Ready Mode, whereas, respectively, on starting of the
fireplace it will disappear!
Main Menu and
Service Settings
The access to the setting is done via the icon, shown below.
11.2.2. Types of modes of the control unit.
Ready mode Modulation 4
Start Modulation 3
Fuel Mode Modulation 2
Ignition Modulation 1
Burning Cleaning
Modulation 5 ECO mode
11.2.3. Main Menu.

Air Correction, Pellets Correction and
Power Limit.
In the first two parameters what is set is the
percentage smoke fan power lag in operation
modes and pause (rest) during the operation of the
screw conveyor!
This can be set within the range of - 15% up to
+15% for both parameters!
The third parameter would be setting the level of
operation of the system – Modulations 5,4.....
down to 1.

Turns/ Flow.