Victoria CLASSIC 40C, Instruction Manual

Page: 13 / 32

05.2020 INSTRUCTION MANUAL for installation and operation of pellet boiler CLASSIC 40C
13
11. Appliance operation.
11.1. Initial ignition.
The installer of the pellet boiler should perform the initial release!
The installer is required:
- to verify that the installation is performed correctly and the expansion vessel meets in size, ensuring safe operation.
- to check the dimensions of the connecting flue pipes and chimney;
- to switch on the power of the pellet boiler and to perform test of the out connectors ;
- to fill up the heating system with liquid through the inlet at pressures to 1.5 bar and make sure that there are no leaks;
- to ensure that all taps between the pellet boiler and heating system are open;
- to set the pellet boiler according to the type of wood pellets used;
- to carry out emission control of flue gases after installation;
- to make a detailed instruction of the user;
Pellet boiler is coated by high temperature resistant paint, but not against corrosion. In case of accumulation of dust, surfaces
can be cleaned with a soft brush or a dry cloth, but in any case with a damp cloth or water.
Upon initial ignition do not place any objects on the pellet boiler and do not touch the outer surface to avoid damaging the
coating. The flavor, which is obtained as a result of the drying of the paint, disappears after a few hours. Ventilate the room
where is located the pellet boiler.
If as a result of overheating or due to incorrect operation the color changes, appeared stain rust or damaged part of the
coverage, you can order spray paint in the color from your dealer.
Before ignition, check: power, door seal, if the combustion chamber is cleaned and whether the display is switched to
standby mode.
11.2. Control panel description.
After start up, on the control display is shown the logo of Victoria-05 for 3
seconds and then switches to main user panel. The icons and functions are
shown as follows:
11.2.1. . Main user control panel.
Display symbol Description
00/00/00
Date display
day/month/year
00 : 00
Hour display
Hour : Minutes
Water Jacket Temperature
The number in the circle indicates the temperature of the water. The number in the large
square indicates the temperature, the sensor has taken.
We would like to maintain 70°С temperature of the water. How do we set this?
We need to touch the icon with the number of the water temperature. An additional page
opens, where we can set the targeted temperature.
Here we can opt between two parameters.
The first one is “Temperature”. Here we set the water temperature to maintain.
The second one is “Hysteresis”. Here we can set how much the temperature to drop below
the preset one to turn off the pump
.