Chapter 4
Configuring System Settings
Remotely Operating the Test Set
22130634
CX300 ComXpert Operation Manual
Rev. 001
4.7 Remotely Operating the Test Set
4.7.1 Establishing VNC Viewer Connection
To View the UI Remotely:
1.
Proceed to the
Remote screen
.
2.
Select the
Enable VNC Access
check box.
3.
To require a password:
a.
Select the
Require password for VNC access
check box.
b.
Type a password in the
Remote access password
field.
4.7.2 Remote Programming Commands
The CX300 can be controlled over a network connection using remote programming
commands. Refer to the
CX300 ComXpert Remote Programming Manual
22146776
for
information and instructions.
4.8 Setting up a Bluetooth® Connection
The following procedures describes how to set up Bluetooth Connection.
1.
Navigate to the
Bluetooth screen
.
2.
Enable the following check boxes:
• Enable Bluetooth
• Allow other devices to pair with this device
3.
Activate Bluetooth on the device that is to be paired with the CX300.
NOTE
IPv6 Network Mode is disabled when a password is required.
This password applies to all remote-access tools; for example, VNC, FTP, and SSH.
NOTE
Bluetooth is a software option that must be enabled to use Bluetooth functionality.
The
Device Name
associated with the CX300 is configured on the
Remote screen
.
See section 4.2.3, “Change the Test Set Name”, on page 4-3
.
