Chapter 4
Configuring System Settings
Establishing a Network Connection
Rev. 001
CX300 ComXpert Operation Manual
22130634
4 - 6
February, 2022
4.4.1.2 Establishing an Ethernet Connection
To Establish an Ethernet Connection to the Device
1.
Connect the ethernet cable to the CX300’s
Ethernet connector
.
2.
Connect the other end of the ethernet cable to an active LAN.
3.
Navigate to the
Network panel
from the System Home Screen, Select the
Network
button
.
4.
Press the
LAN
button
located on the left side of the screen. The UI updates to show
parameters necessary to configure the CX300 to connect to a LAN.
5.
Select desired network mode.
6.
Additional settings are required based on the selected Network Mode of operation.
See one of the appropriate sections to configure the device’s IP settings to match the
LAN settings:
7.
When all settings have been configured, press the
Network On/Off soft-key
to
enable network connectivity. The device establishes an Ethernet connection to the
LAN.
8.
Additional settings are required based on the selected
Network Mode
of operation.
See one of the appropriate sections to configure the device’s IP settings to match the
LAN settings:
•
See section 4.4.2, “Establishing a WiFi Connection”, on page 4-9
•
See section 4.4.1.2.2, “IPv4 Network Mode Settings”, on page 4-7
.
•
See section 4.4.1.2.3, “IPv6 Network Mode Settings”, on page 4-8
.
4.4.1.2.1 IPv4/IPv6 Dual Stack Network Mode Settings
When all settings have been configured, select the
Network On/Off soft-key
to enable
network connectivity. The device establishes an Ethernet connection to the LAN.
IP Dual Stack Address Modes
Setting
DHCP
No additional settings
Static
See section 4.4.1.2.2, “IPv4 Network
.
Stateless