Viavi CX300 ComXpert, Operation Manual, Page: 53 / 256

Chapter 2 Getting Started: Setup and Operation
Verify Test Set Operation
22130634 CX300 ComXpert Operation Manual Rev. 001
The following procedure describes how to REBOOT the Test Set:
1.
Press and hold the
Power button
for approximately 1 second, then release.
2.
When prompted, select
Reboot
from the
Power Options screen
to reboot the
test set.
3. Wait while the test set performs a series of automated processes. Do not
interrupt the
Reboot
process or unsaved information may be lost.
2.2.5 Forced Shutdown
To initiate a forced shutdown, press and hold the Power button for approximately
7 seconds to reboot process the unit.
2.3 Verify Test Set Operation
The CX300 ComXpert has an automated Built-in-Test (BIT) procedure. The BIT is referred
to as a Self Test. The CX300’s Self Test evaluates the general functionality of the test set’s
generate and receive function, instruments and switches to ensure the device is operating
properly.
See section 6.2, “CX300 Self Test Procedure”, on page 6-4 for instructions to run the
CX300 self test.
2.4 CX300 Control and Operation
The CX300 can be controlled locally or remotely.
• Local Control and Operation
•
When controlled locally, the CX300 is controlled and operated using the
touchscreen display or an external mouse and keyboard.
•
Remote Control and Operation
• When the CX300 is connected to a network, the test set can be controlled
remotely using a viewing application or remote programming commands.
• See section 4.7, “Remotely Operating the Test Set”, on page 4-15 for
instructions for configure the test set for remote operation.
NOTE
This method should not be used when routinely powering down the test set. When a
forced shutdown is performed, unsaved information will be lost.
NOTE
The following procedure is used to verify that the CX300 is operating properly. This
procedure is not intended to verify that the CX300 is operating to specified
performance parameters.