Chapter 4
Configuring System Settings
Test Set Display Settings
22130634
CX300 ComXpert Operation Manual
Rev. 001
4.2.3 Change the Test Set Name
The following procedure describes how to change the name used to identify the test set
for Bluetooth and remote connections. Change the test set name by using the following
steps:
1.
Navigate to the
Remote screen
.
2.
Select the
Device Name
field.
3.
Enter the desired name for the test set.
4.
Press the
OK
button
to apply the change.
4.2.4 Configuring the Screen Saver
The following procedure defines how to configure the screen saver.
1.
Navigate to the
Display screen
.
2.
To enable the screen saver, select the check box next to
Enable automatic
screen saver
.
3.
To change the message displayed as a screen saver, select the
Message
field,
and type the message to be displayed.
4.
Press the
OK
button
to confirm.
5.
To specify the time to wait until the screen saver begins:
a.
Select the
Delay
field
. Enter the amount of time to wait before the screen
saver is activated.
b.
Press the
OK
button
to confirm.
4.2.5 Enable a screen saver password
The following procedure identifies how too enable a screen saver password.
1.
Select the
Screen saver password
check box.
2.
Enter a password in the field.
3.
Press the
OK
button
to confirm.
4.
Record password for future reference.
CAUTION
If a screen saver is activated, and the password is lost or forgotten, the test set will
have to be re-imaged to restore the test set to operating condition.
“Re-imaging the System”, on page 4-29
for instructions.
