VET-PRO
Operator’s Manual
31
Program Setting
F
Note:
Whenever you decide to set a new program, follow the
instructions at the bottom of the screen.
Note
:
-If one of the values is changed during the programming
mode, the pump will not store the new value, unless changes
are confirmed by pressing the
START/OK
key.
-If the flush key is activated during data setting, the pump
will return to the original (previous) screen, once flushing is
completed.
Step 1 Rate
100 ml/h
.
The pump will display the previous rate for the
first step. Set a new rate, using numeric keys,
or confirm pressing
START/OK
.
Press OK for Volume
Step 1 Volume
1000 ml
.
Pump will display the previous volume for first
step. Set a new volume, or confirm pressing
START/OK
key.
Press OK to continue
3.
Pump will display the rate for step 2. Repeat directions as for step 1 and
repeat through all the steps required, up to 25.
Step 11 Rate
0 ml/h
4.
Press OK for Volume
After last required step, set rate to
zero
. This
indicates that all data required for the protocol
has been set. All protocols following the last
set protocol, will be automatically zeroed
.Press
START/OK
to confirm.
Total Steps 10
Total Volume 5000ml
5.
Press OK to start
After last step rate was set to zero or after 25
steps are completed, the pump will display the
accumulated data setting, to enable comparison
and verification. Press
START/OK
to start the
program or
STOP/NO
to scroll through all the
protocol settings again.
Setting Program Delay– Refer to page 48.
Rate Step 1 of 10
6.
During the program operation, the display
updates the user on which step the pump is
running.
S
T
E
p
100 ml/h
F
Note:
Pressing the
STOP/NO
key shall erase the last digit. Once
no digit is displayed, pressing the STOP/NO key will
change the screen to show the previous display.
