The right part of the overview screen, the
"Configuration-Window
" is used
to show a picture of the selected Master, Slave or Display devices in addition
with the characteristic parameter values e.g.
Part No., Type, Primary- and
Secondary Range, potential Sensor type and Address
,
During the configuring process of the different devices, this window shall be
used to set all required parameters.
The left screen part,
"
Navigation-Window"
shows the Configuration.
Subcategories show up
after a mouse-click to
"+"
on the left side near
the configured device
(Master/Slave/Display).
With a click to
"
-
"
the
Subcategories view is
closed again.
June 2009
Training WinGauge Software
page 9
Summary of Contents for CANcockpit Series
