by configuration. An adjustable frequency divider reduces input frequency, so that it can be processed by the Microprocessor.
U
Only one frequency input (either Input 1 or 2) can be defined as road speed input.
PIN 20: Switch Output 1
Maximum voltage:
32 V
Maximum current: 0.5 A
Warning lamp to be connected between output and supply voltage (terminal 15 or terminal 30).
Switch output controlled by the Microprocessor. The pin turns the output either on or off (static). The output is an open drain
and acts like a low switch to ground.
U
Save against high current with a Fuse 0.5 A!
PIN 21: Switch Output 2
Identical with Switch output 1
PIN 22: Not connected
PIN 23: Not connected
PIN 24: External Switch
Switch has to be connected between this pin and GND
Satellite
PIN 1-3: Satellite Bus Interface (Satbus):
Bus signal levels:
5 V ± 10%
Ground reference:
± 100 mV
Max. Bus length:
10 m
Cable impedance:
Standard cable
Connector:
4-Pin MATE-N-LOK AMP
Satbus is used in a Master-/ Slave-configuration and is bi-directional with half-duplex communication. When the system is ac-
tive, a constant clock signal is produced on the bus by the Master gauge.
Bit-rate on Satbus = 31.25 kHz.
2. Functional Specification
Product Manual
Technische Änderungen vorbehalten Technical details subject to change
2 - 11
TU00-0726-0000002
0609
Pin
Description
Pin
Description
1
-
3
GND
2
Satellite - Bus
4
Power Supply
Summary of Contents for CANcockpit Series
