![background image](http://html.mh-extra.com/html/vdo/cancockpit-series/cancockpit-series_product-manual_858176031.webp)
Technische Änderungen vorbehalten Technical details subject to change
2 - 21
TU00-0726-0000002
0609
2.5.5
Service
The Service message is based on the Hourmeter or Odometer.The service message indication can be configured via
WINgauge. There are 15 independent service messages with customer specific settings, which can be configured via
WINgauge. The service messages are implemented as periodic intervals. A message which should be indicated only once,
the quantity of intervals would then be 0. Configuration data is stored in EEPROM.
For each of the 15 Service messages following can be specified in a table:
1.
Service code number: Range: 1 to 255. 0 needs to be entered to disable this service function.
2.
First message after x hours:
( 1h <= x <= 65.000 h )
3.
Periodic service time:
Range: 1h to 4.095h. If 0h is selected, it means only once (not periodic).
If a Service message has expired, this service code is displayed as a decimal number together with the common service
symbol on the dot-matrix display. The Service message display remains active until this service code is reseted.
2.5.5.1Reset of Service messages
The reset of the service message function is possible first if it occured and not before.
When a one-time service message will be reseted, then this Service message will be disabled by writing 0 into the service
code field of the Service message table in EEPROM.
When a periodic interval will be reseted then the periodic service time will be added to the hours of the current hourmeter va-
lue. This will ensure, that even if a Service message is reseted later than required, the time to the next service indication will
be the periodic interval time as specified.
Example:
Service message No.:
12
Service code:
153
First service after:
300 h
Periodic service: 100 h
The reset of the Service message is part of the system check function (part of safety check).
Procedure for resetting a Service message:
1. With ignition switched off, push the button and hold down while ignition is being turned on, then the system check function
is activated and clears the contents of the DTC List.
2. If there are any service messages active, then they will be displayed on the Dot-Matrix Display starting with the first active
service message. If the button is then pressed and held for 5 seconds or longer, then this Service message will be rese-
ted. The next active Service message is displayed afterwards. To proceed to the next active service message without re-
setting the displayed code the button needs to be pressed shortly (<5 sec). If all active service codes have been display-
ed, then the system check function is started.
2. Functional Specification
Product Manual
Event
Time (hourmeter)
Display
First service code displayed after
300 h
153
Reset of this service at
340 h
Next service display at
440 h
153
Summary of Contents for CANcockpit Series
