Configuration with web browser
54
VideoJet 400
The transparent data link is maintained by the first device as for the
audio link, although the data connection is automatically torn down
after 15 seconds inactivity and another device can exchange trans-
parent data with the receiver.
For the multilink mode, the network does not have to be suitable for
multicast operation, as the
VideoJet 400
is also multi-unicast
compatible. The duplication of the data in the device requires a high
computing power and could under certain circumstances lead to a
deterioration in the image quality. In this case, you should reduce
the data rate of the transmitter slightly.
With the setting
Multilink On
and
Multicast group IP address =
0.0.0.0
, the device operates in multi-unicast mode (copying the
data streams in the device).
With the setting
Multilink On
and a valid Multicast group IP
address, the device operates in multicast mode (duplication of the
data streams in the network).
Enable multicast streaming:
During multicast streaming, the
VideoJet 400
sends a perma-
nent data stream to the specified group IP address. No specific
receiver is defined. Each receiver is thus able to receive the data.
The transmission rate is determined purely by the transmitter and
has to be set there. For this, a valid multicast group IP address must
be set.
Multicast group IP address:
A precondition for the multicast mode in a multicast-compatible net-
work is the establishment of a special IP address (class D address).
The network must support the establishment of a group IP address
and the Internet Group Management Protocol (IGMP). The address
range is from 224.0.1.0 to 238.255.255.255.
Multicast video port:
The video port does not have to be configured manually and is
shown here only for information for special applications.
Multicast audio port:
The audio port does not have to be configured manually and is
shown here only for information for special applications.
