Installation
30
VideoJet 400
Assigning the
IP address
In order for the
VideoJet 400
to be operated in your network, it
has to be assigned a valid IP address for your network.
The following address has been preset at the factory:
192.168.0.1
)
Start a terminal program, e.g. HyperTerminal.
)
Enter
i
. The existing IP address is displayed and you are prompted
to enter a new IP address.
)
Enter the new IP address and press the [ENTER] key. The new IP
address is displayed and is immediately valid.
Further
parameters
Using the terminal program, you can check and, if necessary,
change further fundamental parameters.
For this, you can use the following commands:
?
Displays the 'Help' page
i
Displays the current IP address and prompts the user to enter a
new IP address
s
Displays the current subnet mask address and prompts the user
to enter a new address
g
Displays the current gateway address and prompts the user to
enter a new address
a
Displays the current alarm IP address and prompts the user to
enter a new address
c
Sets up a connection to the alarm IP address
d
Terminates the current connection
m
Displays the MAC address of the
VideoJet 400
v
Displays the hardware and software version of the
VideoJet 400
b
Displays the current data rate
