Manual
22
OPTIONS
Dispenser operating modes
It is possible to select the desired operating mode either by corresponding printer driver or label
design software.
The printer supports the following operating modes:
Off
It is printed without the labels are dispensed.
I/O static:
The input signal is analyzed, i.e. it is printed as long as the signal exists. The printer prints the number
of prints which you entered at print start.
The set dispenser offset is not taken into consideration.
I/O static continuous:
For description of this operating mode please see I/O static.
Continuous means that it is printed as long as new data is transferred via interface.
The set dispenser offset is not taken into consideration.
I/O dynamic:
The external signal is analyzed dynamically, i.e. in case the printer is in 'waiting' mode then a single
label is printed at each signal change. After the print the set dispenser offset is taken into
consideration, i.e. this results to a backfeed.
I/O dynamic continuous:
For description of this operating mode please see I/O dynamic.
Continuous means that it is printed as long as new data is transferred via interface.
Photocell:
The printer is controlled via photocell. The printer prints automatically a label when the user tears off
the label at the tear-off edge. The print order is finished at the nominal number of labels.
Photocell continuous:
For description of this operating mode please see Photocell.
Continuous means that it is printed as long as new data is transferred via interface.
