Manual
17
TEAR-OFF
In case the printer is not equipped with a cutter or a dispenser, then it has as default an integrated
tear-off edge.
After a print order you can lead the labels together with the supporting paper over the tear-off edge to
tear them off.
Standard labels are suitable when using the tear-off edge. Continuous labels are only limited to use as
the label adhesive can lead to contamination of the teething.
Using tear-off
•
Unscrew the cover.
•
Turn the cover at 180°.
•
Screw on the cover again.
Attention:
The polished teething causes danger of injury.
To make sure that the labels after the print are positioned with the gap at the teething it is necessary
to set in the corresponding software the y-offset for the tear-off to approx. 17 mm.
