Manual
11
Rewinder in front
Open the printer cover.
Open printhead (A) by turning the lever (B) against clockwise direction.
Remove the outside label mounting plate (C).
Load the label roll with inner winding onto the unwinding roll (D) and attach again the label mounting
plate (C).
Lead the label material (E) below the label guiding (F) and take care that the material runs through the
photocell (G).
Lead the supporting paper over the pressure roll (H) and clamp it with the designated handle at the
rewinding roll (J).
To move the printhead (A) down, turn the lever (B) in clockwise direction until it locks.
Adjust the adjusting rings (J) of the label guiding to the width of material.
Close the printer cover.
