Manual
13
Loading of labels in peel-off mode
Open the printer cover.
Open printhead (A) by turning the lever (B) against clockwise direction.
Remove the outside label mounting plate (C).
Load the label roll with inner winding onto the unwinding roll (D) and attach again the label mounting
plate (C).
Lead the label material (E) below the label guiding (F) and printhead (A) and take care that the labels
run through the photocell (G).
Move the axe first to the left side then lift the whip (H) to the bottom.
Strip some labels (E) from the supporting paper.
Lead the supporting paper (I) over the whip (J), then the transport roll (K) and the plastic roll (K).
Press again the whip (H) to the top.
Lead the supporting paper (I) to the outside of printer. In case of an existing rewinding unit clamp it
with the designated handle at the rewinding roll.
Close the printer cover.
We recommend a minimum label height of 15 mm.
