Manual
10
Loading of labels in rewinding mode
Rewinder behind
Open the printer cover.
Open printhead (A) by turning the lever (B) against clockwise direction.
Remove the outside label mounting plate (C).
Load the label roll with inner winding onto the unwinding roll (D) and attach again the label mounting
plate (C).
Lead the label material (H) below the label guiding (E) and take care that the material runs through the
photocell (F).
Lead the supporting paper (I) between pressure roll and dispenser whip (G) to the rear.
Clamp the supporting paper (I) with the designated handle (H) at the rewinding roll (J).
To move the printhead (A) down, turn the lever (B) in clockwise direction until it locks.
Adjust the adjusting rings (K) of the label guiding to the width of material.
Close the printer cover.
