Manual
23
Cutter operating modes
It is possible to select the desired operating mode either via the corresponding printer driver or the
label design software.
The printer supports the following operating modes:
Off
It is printed without cutting the labels.
Without backfeed
A cut is effected after each printed label.
The selection of this operating mode is only useful if the upper part of the label does not contain
printable data.
With backfeed
A cut is effected after each printed label.
Interval with final cut
A cut is effected after a fixed number of labels which you have already selected at print start and
additionally at the end of the print order.
Interval without final cut
A cut is effected after a fixed number of labels which you have already selected at print start.
However, at the end of the print order no final cut is effected despite the set interval is at the end of the
print order at the same time.
Final cut
A cut is only effected at the end of the print order.
Single cut
Press the
key (> 2 sec.) to release a single cut. Make sure that the printer is in offline mode.
