Manual
12
Loading of labels in cutter mode
Open the printer cover.
Open printhead (A) by turning the lever (B) against clockwise direction.
Remove the outside label mounting plate (C).
Load the label roll with inner winding onto the unwinding roll (D) and attack again the label mounting
plate (C).
Lead the label material (E) below the label guiding (F) and the printhead (A) and take care that the
labels run through the photocell (G).
Lead the label material between inserting angle (H) and cutter ledge.
To move the printhead (A) down, turn the lever (B) in clockwise direction until it locks.
Adjust the adjusting rings (I) of the label guiding to the width of material.
Close the printer cover.
