Manual
7
INITIAL OPERATION
Turn on the power switch at the rear of the printer.
Load label material and if required transfer ribbon.
Start measuring by pressing the keys
and
one after the other. Make sure that the printer is in
online mode (green LED lights up).
With the
key it is possible to change from online mode (green LED lights up) to offline mode
(green LED flashes).
Note:
To guarantee a correct measuring at least two complete labels have to run through the
photocell (not when using continuous labels).
INSTALLATION
Note:
Before initial operation the operating conditions described at the end of this operating manual
have to be granted.
Please check the printer status immediately after the receipt, to be sure that nothing was damaged on
the route of transportation.
As the delivery is customized, please compare the supplied accessories with your order.
Note:
Keep the
original packaging
for possible later deliveries
Put the printer onto a suitable ground, avoiding exposure to bright sunlight.
Please avoid high humidity and dust environment and make sure that the printer is not used in dump
or wet area.
Our printers are exclusive for printing on labels, continuous paper and similar materials.
Operate the printer only with the original cable with safety contact.
Note:
When servicing or repairing, the power switch has to be turned off and the cable
disconnected.
Connect the power line at the rear of the printer (see illustration below).
Connect the interface cable (RS-232) at the rear of the printer and lock it.
Make a connection to the computer at a free interface.
You can operate the printer via printer driver or via our label design software.
While creating connexions you have to switch off all devices (printer, PC, etc.) that you want to
connect. If you want to remove connexions you have to switch off the devices, tool.
Caution:
Not open printer cover in order to avoid electrical shock!
