Valco baby MCP-25/MS, Manual

Page: 17 / 179

Section 4
—
Basic Features MCP-25/MS
Valco Cincinnati 4-3
12 Pressure transducer LEDs (2)
• If LED 1 or 2 illuminates, the corresponding pressure transducer is active. These LEDa get
brighter as the glue pressure increases and dimmer as the pressure decreases.
• If LED U illuminates, the pressure transducer supply voltage is OK.
13 Encoder LEDs (2)
• If the LED does not illuminate, the corresponding encoder is idle.
• If the LED illuminates, the corresponding encoder is operating. These LEDs get brighter as the
speed of the parent machine increases and dimmer as the speed decreases.
• If the LED U illuminates, the encoder supply voltage is OK. If this LED does not illuminate, there
is a fault with either the 15V or 24V supply.
14 Internal supply voltage LEDs (5VDC and 24VDC)
15 Help button
Pressing this button displays information about the current menu shown in the display.
16 Function buttons (F1-F5)
These buttons correlate to the screen information above them.
17 Sensor on/off buttons
The LED next to the sensor number illuminates when the sensor is on. The LED goes out when the sensor
is off.
18 Sensor measurement status
• Green = indicates that glue is under the sensor
• Red = indicates that the last product was a fault
• Orange = indicates that glue is under the sensor and that the last product was a fault
19 Sensor status LED
• Off = indicates that the sensor is turned off
• Green = indicates that the sensor is turned on
• Red = indicates that either the sensor is not connected or that there is a sensor defect