Valco baby MCP-25/MS, Manual

Page: 105 / 179

Section 11 — Glue-Pressure-Edit Menu MCP-25/MS
Valco Cincinnati 11-2
MC051 (June 2002)
4 Unit of Measure
This field indicates the unit of measure (either millimeters or inches) that was selected in the setup menu. (See
Section 8—Setup Menu
for information about how to change the unit of measure.)
5 Velocity
V = product speed (velocity). This value is entered in either meters per minute or feet per minute, depending
which unit of measure was selected in the setup menu.
“min.” = Parent machine idle
“max.” = Maximum parent-machine speed
6 Glue Pressure
P% = glue pressure in percent of the maximum possible glue pressure. If “bar” or “psi” is displayed, the glue
pressure is entered in absolute values.
Note
! This function may not be active if only one transducer has been selected in the setup menu.
Note! This option is not visible if it is not selected in special setup.
Note! This option is not visible if it is not selected in special setup.
7 F1
Press F1 ( ) to display the glue-pressure curve for pressure transducer 2. Up to two pressure transducers
are available in one job.
8 F2
Pressing F2 (Delete) deletes the current pressure table.
9 F3
Pressing F3 ( ) increases the values of the whole pressure table. All points of the pressure table will be
increased or decreased proportionally, and the glue-pressure changes take effect immediately.
10 F4
Pressing F4 ( ) decreases the values of the whole pressure table. All points of the pressure table will be
increased or decreased proportionally, and the glue-pressure changes take effect immediately.
11 F5
Pressing F5 (Insert) automatically imports the parent-machine speed and corresponding glue-pressure values
into the glue-pressure table.