Valco baby MCP-25/MS, Manual

Page: 84 / 179

Section 9 — Glue-Pattern-Edit Menu (Standard) MCP-25/MS
Valco Cincinnati 9-2 MC051 (July 2002)
Glue-Pattern-Edit Parameters
Values for the glue-pattern data must correspond to the values chosen in the setup menu (either in millimeters or 1/
100 inch).
Example: Unit of measure selected in the setup menu is millimeters: 0100 = 100 mm
Unit of measure selected in the setup menu is inch: 01.00 = 1 inch
Note! The information displayed below is an example only.
1 Start Point of Pattern 1 (Pattern-Delay 1)
The distance from the leading edge of the product to the start of the first glue pattern. This value must be
entered in either millimeters or 1/100 inches, depending on the setup of the control. Maximum allowable
delay is 9999 mm or 99.99 inches. Pressing F5 (>>>) displays values for glue patterns 3, 4, and 5.
2 Glue-Pattern 1
The length of the first glue pattern. This value must be entered in millimeters or 1/100 inches, depending
on the setup of the control. Maximum allowable pattern length is 9999 mm or 99.99 inches. Pressing F5
(>>>) displays values for glue patterns 3, 4 and 5.
3 Start Point of Pattern 2 (Pattern-Delay 2)
The distance from the leading edge of the product to the start of the second glue pattern. This value must be
entered in either millimeters or 1/100 inches, depending on the setup of the control. Maximum allowable
delay is 9999 mm or 99.99 inches. Pressing F5 (>>>) displays values for glue patterns 3, 4, and 5.
4 Valve Number
This field indicates the number of the valve to which the information on the screen pertains. Up to 8 valves
are available for a job. Press F3 (FORWARD) or F4 (BACK) to select the information for a different valve.
5 Cell-to-Gun Dimension
Enter the distance between the glue valve’s nozzle opening and the middle of the scanner. Enter this value
in millimeters or 1/100 inches depending on the setup of your MCP-25 (see “Setup menu”). Maximum
distance = 19999 mm or 199.99 inches.
6 Scanner Assignment
Determine which scanner (or start signal) to use with the glue pattern of a channel (valve). If all scanners
are installed, you can choose any one of four scanners for a channel (valve).
Note ! Scanner 5 can be used as an encoder start signal (0 signal). (See “Encoder Configuration” in
Section 8—Setup Menu. )
11
2
4
10
Delete Copy
F1
F2 F3 F4 F5
1
1
00000
00000
00000
00000
00000
Job: 1 [mm]
Lockout = 0 00000
MODE 0
16
5
6 7 8
9
12 13
14
15
1
Repeat factor = 01
3
+ Chan.
^
^
Chan. -