Valco baby MCP-25/MS, Manual

Page: 115 / 179

Section 12 — Inspection Menu MCP-25/MS
Valco Cincinnati 12-6 MC051 (July 2002)
Fault-Counter Data
To view fault-counter data, follow these steps:
1. At the inspection screen, press F2 (Counter).
The fault-counter-data screen displays
(Figure 12-11).
2. To see details about the faults, press the
button. The “details” screen displays
(Figure 12-12).
To print a faults data report, follow these steps:
1. Press F2 (Print).
Note! A printer must be connected to your
system in order to print information.
Section 8—Setup Menu contains informa-
tion about how to configure the faults data
report.
To reset the error counter to zero, follow these steps:
1. Press F3 (Delete). The following message
displays: “To reset error counter to zero, enter
PIN code” (Figure 12-13).
2. Enter the PIN code.
3. Take one of the following actions:
• Press F3 (OK) if the pin code you entered
is correct.
• Press F4 (Cancel) to return to the counter
inspection screen.
• Press F2 (PIN) to change the PIN code.
The Change PIN screen displays (Figure
12-14). Enter the old and new PIN codes.
Then, press F1 (OK).
Figure 12-12. Details Screen
Fault Evaluation Section 1 _ _ _ per shift
Start: 0
End: 0
Total Length: 0
Glue volume: 0
Print Delete
F1 F2
F3 F4 F5
<<<
Job: 1 [m/min]
F1 F2 F3
F4 F5
PIN Cancel
Figure 12-13. Fault-Counter-Data Screen with
Message
OK
To reset error
counter to zero
Enter PIN-code
- - - - - - - - - - - -
Job: 1 [m/min]
F1
F2 F3 F4 F5
PIN
Cancel
Figure 12-14. Change-PIN Screen
OK
Change PIN
Old PIN:
New PIN:
F2
Figure 12-11. Fault-Counter-Data Screen
Fault Evaluation Section 1 _ _ _ per shift
Total Products: 62307
Products outside Tolerance: 2233
Print Delete
<<<
F1 F2 F3 F4 F5