V-ZUG Supremo HSL, Operating Instructions Manual

Page: 25 / 200

21
EN
DISPLAYED MESSAGES
DISPLAYED MESSAGE POSSIBLE CAUSE SOLUTION
FILL TANK The water tank is empty or positioned
incorrectly. Fill the tank with water and/or insert it correctly,
pushing it as far as it will go.
GROUND TOO FINELY ADJUST
MILL
(alternating with)
PRESS The grinding is too fine and the
coffee is delivered too slowly. Turn the grinding adjustment dial one click clockwise
towards “7”.
GROUND TOO FINELY ADJUST
MILL
(alternating with)
PRESS
(then)
FILL TANK The tank has been removed during
delivery.
There is air in the hydraulic circuit.
Insert the tank and press the icon (B4).
“HOT WATER PRESS ” is displayed.
Press the
icon again.
The appliance is once again ready for use.
EMPTY GROUNDS CONTAINER The grounds container (A4) is too
full or more than three days have
passed since you last made coffee
(this guarantees correct hygiene of
the machine). Empty the grounds container and clean, then replace.
Important: when removing the drip tray, the grounds
container MUST be emptied, even if it contains few
grounds.
If this is not done, when you make the next coffees, the
grounds container may fill up more than expected and
clog the machine.
INSERT GROUNDS CONTAINER After cleaning, the grounds container
has not been replaced. Open the service door and insert the grounds container.
ADD PRE-GROUND COFFEE The “pre-ground coffee” function has
been selected without placing any
pre-ground coffee in the funnel.
The funnel (A21) is blocked. Extract the appliance and place pre-ground coffee in
the funnel.
Empty the funnel with the help of a knife as described
in the section “Cleaning the pre-ground coffee funnel”.
DESCALE
(alternating with)
COFFEE STANDARD The machine must be descaled. The descaling procedure described in the “Descaling”
section needs to be performed as soon as possible.
LESS COFFEE Too much coffee has been used. Select a milder taste or reduce the quantity of pre-
ground coffee, then make the coffee again.
FILL BEANS CONTAINER The coffee beans have run out. Fill the beans container
INSERT INFUSER ASSEMBLY The infuser has not been replaced
after cleaning. Insert the infuser as described in the section “Cleaning
the infuser”.
CLOSE DOOR The service door is open Close the service door.
GENERAL ALARM The inside of the appliance is very
dirty. Clean the inside of the appliance thoroughly, as
described in the section “Cleaning and maintenance”.
If the message is still displayed after cleaning, contact
a service centre.
WATER CIRCUIT IS EMPTY
FILL WATER CIRCUIT
alternating with
HOT WATER PRESS
The water circuit is empty
Connect the hot water nozzle (A10) and press icon
(B4) to deliver water from it, until it flows out normally.