V-ZUG Supremo HSL Operating Instructions Manual Download Page 16

Page: 16 / 200

USING THE APPLIANCE FOR THE FIRST TIME

•

Coffee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of coffee
in the mill.

•

Customise water hardness as soon as possible following
the instructions in the “Water hardness” section.

1. Connect the appliance to the mains electricity supply and

place the main switch (A23) in position I.

2. The appliance displays “FILL TANK” in different languages.

Extract the water tank (fig. 4), rinse and fill with fresh water
without exceeding the MAX line. Replace and push as far as
it will go.

3. Choose the language (the languages scroll through at in-

tervals of about 3 seconds):

When the message “PRESS TO SET TO ENGLISH” is dis-
played, press the

icon (B4) (fig. 3) for 3 seconds until

“ENGLISH SET” is displayed. If you set the wrong language,
follow the instructions in the “Setting the language” sec-
tion.

If your language is not available, select one from those dis-
played (the instructions refer to English).

Then follow the instructions displayed:

4. Place a cup under the hot water spout (fig. 5).

(If the hot water spout is not inserted, the appliance dis-
plays “INSERT WATER SPOUT”. Attach the spout as shown
in figure 6. The machine displays “HOT WATER PRESS ”.
Press the

icon (B4), a little water comes out of the

spout.

5. After that the machine displays “TURNING OFF PLEASE

WAIT” and goes off.

6. Extract the appliance by pulling it out using the handles

(fig. 7).

Open the lid and fill the container with coffee beans, then
close the lid and push the appliance in.

The coffee machine is now ready for normal use.

Important!

Never introduce pre-ground coffee,

freeze dried coffee, caramelised beans or anything else which
could damage the appliance.

Please note:

When using the appliance for the first

time, you need to make 4-5 cups of coffee and 4-5 cappuccinos
before the appliance gives satisfactory results.

Please note:

Each time you turn the coffee machine

on by the main switch (A23), it performs an AUTO DIAGNOSTICS
cycle and then goes off.
To turn it on again, press the ON/stand-by button (A7) (fig. 1)

TURNING ON AND HEATING UP

Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this cycle.

Danger of burns!

During rinsing, a little hot water

flows from the coffee spouts.

To turn the appliance on, press the ON/stand-by button (A7) (fig.
1). The message “HEATING UP PLEASE WAIT” is displayed.
When heating is complete, the message changes to “RINSING”.
The appliance is at temperature when the message “COFFEE
STANDARD” is displayed.

MAKING COFFEE USING COFFEE BEANS

1. The appliance is preset to make coffee with a standard

taste. You can choose coffee with an extra mild, mild,
standard, strong or extra strong taste. There is also a pre-
ground coffee option. To choose the required taste, press
the

icon (B2) (fig. 8) a number of times. The required

coffee taste is displayed.

2. Place 1 cup under the spouts to make 1 coffee (fig. 9) or 2

cups for 2 coffees (fig. 9).

Lower the spouts as near as possible to the cup for a cream-
ier coffee (fig. 10).

3. Press

the

icon (B3) (fig. 11) to select the type of

coffee (espresso, coffee, long coffee).

Now press the

icon (B4) (fig. 12) if you want to make

one coffee and the

icon (B5) (fig. 13) if you want to

make 2 coffees. The appliance now grinds the beans and
starts delivering the coffee into the cup.

Once the set amount of coffee has been delivered, the ma-
chine stops delivery automatically and expels the exhaust-
ed coffee grounds into the grounds container.

4. After a few seconds, the appliance is ready for use again.
5. To turn the appliance off, press the ON/stand-by button

(A7) (fig. 1).

(Before going off, the appliance performs an automatic
rinse cycle. Take care to avoid scalds).

NOTE 1: If the coffee is delivered a drop at a time or not at all, see
section “Adjusting the coffee mill”.
NOTE 2: If the coffee is delivered too fast and the cream is not
satisfactory, see section “Adjusting the coffee mill”.
NOTE 3: Tips for a hotter coffee:
•

Proceed as described in the section “Menu settings”, “rins-
ing” function.

•

Unless preheated, do not use excessively thick cups as they
will absorb too much heat.

•

Preheat the cups by rinsing them with hot water.