V-ZUG Supremo HSL, Operating Instructions Manual

Page: 17 / 200

13
EN
NOTE 4: Coffee delivery can be interrupted at any moment by
re-pressing the previously selected icon which remains lit during
the operation.
NOTE 5: As soon as delivery is finished, to increase the quantity of
coffee in the cup, just keep pressing the previously selected icon
within 3 seconds after delivery has finished.
NOTE 6: When the appliance displays “FILL TANK”, fill the tank
with water or the appliance will not deliver coffee. (It is normal
for there to be a little water left in the tank).
NOTE 7: After about 14 single (or 7 double) coffees, the appliance
displays “EMPTY GROUNDS CONTAINER”.
Even if not full, the empty waste coffee container message is dis-
played 72 hours after the first coffee has been delivered.
For the 72 hours to be calculated correctly, the machine must
never be turned off with the main switch in the 0 position.
To clean, open the service door on the front of the appliance
by pulling the spout (fig. 16), extract the drip tray (fig. 17) and
clean.
When cleaning, always extract the drip tray completely.
Important! When extracting the drip tray, the
grounds container MUST always be emptied.
If this is not done, the machine may be clogged.
NOTE 8: Never extract the water tank while the machine is de-
livering coffee.
If it is removed, it will not be possible to make the coffee and the
appliance will display some messages (see page 21).
CHANGING THE QUANTITY OF COFFEE IN THE CUP
The appliance is set by default to make a standard quantity of
coffee.
To select the quantity of coffee, press the
icon (B3) (fig.
11) repeatedly until the message corresponding to the required
quantity of coffee is displayed:
Corresponding coffee quantity (ml)
ESPRESSO
ถ
30
COFFEE
ถ
110
LONG COFFEE
ถ
150
Programming quantity
To modify the quantity of coffee delivered, proceed as follows:
1. Place a cup under the coffee spouts ( fig. 9).
2. Keep
the icon (B4) (fig. 12) pressed until the message
“PROGRAM QUANTITY” is displayed and coffee delivery be-
gins. Then release the icon.
3. As soon as the coffee in the cup reaches the required level,
press the same icon again.
The quantity set has now been programmed.
ADJUSTING THE COFFEE MILL
The coffee mill is preset in the factory and should not require
adjusting.
However, if after making the first few coffees you find that de-
livery is either too fast or too slow (a drop at a time), this can
be corrected by adjusting the grinding adjustment dial (fig. 14).
Important! The grinding adjustment dial must only
be turned when the coffee mill is in operation.
For slower delivery and creamier coffee, turn one click anticlock-
wise (finer pre-ground coffee).
For faster delivery (not a drop at a time), turn one click clockwise
(coarser pre-ground coffee).
MAKING ESPRESSO COFFEE WITH PRE-GROUND
COFFEE (INSTEAD OF BEANS)
• Press the icon (B2) (fig. 8) and select the pre-ground
coffee function.
• Extract the machine by pulling it outwards using the han-
dles (fig. 7).
• Lift the central lid, place one measure of pre-ground coffee
in the funnel (fig. 19), push the appliance in then proceed