V-ZUG Supremo HSL Operating Instructions Manual Download Page 18

Page: 18 / 200

as described in the section “Making coffee using coffee beans”.

Please note: You can make just one coffee at a time by
pressing the

icon (B4) (fig. 12).

•

After using the machine with pre-ground coffee, to go back
to making coffee using beans, disable the pre-ground cof-
fee function by pressing the

icon (B2) (fig. 8) again.

NOTE 1: Never introduce pre-ground coffee when the machine is
off or it could spread through the inside of the appliance.
NOTE 2: Never add more than 1 measure, otherwise the appli-
ance will not make the coffee.
NOTE 3: Use the measure provided only.
NOTE 4: Introduce only pre-ground coffee for espresso coffee
machines into the funnel.
NOTE 5: If more than one measure of pre-ground coffee is used
and the funnel clogs, push the coffee down with a knife (fig. 21)
then remove and clean the infuser and machine as described in
the “Cleaning the infuser” chapter.

DELIVERING HOT WATER

•

Make sure the water spout is in place (fig. 6).

•

Position a container under the spout.

• Press

the icon (B6) (fig. 20).

The message “HOT WATER” is displayed and hot water flows
out of the hot water spout into the container below.

You should not deliver hot water for more than 2 minutes at
a time.

To interrupt the flow, press the

icon (B6).

The appliance stops delivery once the set quantity is
reached.

CHANGING THE QUANTITY OF HOT WATER

The appliance is set by default to automatically deliver approx
300 ml.
To modify these quantities, proceed as follows:
1. Position a container under the spout.
2. Press

the icon (B6) again until “HOT WATER PROGRAM

QUANTITY” is displayed, then release the

icon (B6).

3. When the hot water in the cup reaches the required level,

press the

icon (B6) again.

The machine is now reprogrammed with the new quantity.

MAKING CAPPUCCINO

•

Select the taste of the coffee you want to use to make the
cappuccino by pressing the

icon (B2).

•

Remove the lid of the milk container.

•

Fill the container with about 100 ml of milk for each cap-
puccino to be prepared (fig. 23).

Never exceed the MAX level (corresponding to about 750
ml) marked on the container.

You should ideally use skimmed or semi-skimmed milk at
refrigerator temperature (about 5°C).

•

Make sure the intake tube is correctly inserted in the rubber
washer (fig. 24) then replace the milk container lid.

Position the froth regulator between the words cappuccino
and caffe latte printed on the milk container lid.

The quality of froth can be adjusted by moving the regu-
lator towards the word “caffe latte” for a denser froth (hot
milk). Moving it towards the word “cappuccino” obtains a
less dense froth.

no froth (hot milk)

«Denser» froth

froth regulator

«Less dense» froth

•

Remove the hot water spout (fig 6) and attach the milk
container to the nozzle (fig. 25).

•

Position the milk tube as shown in fig. 26 and then place a
sufficiently large cup under the coffee and milk spouts.

• Press

the icon (B8). “CAPPUCCINO” is displayed and af-

ter a few seconds, frothed milk flows out of the milk spout
into the cup below. (Delivery stops automatically).

•

The appliance delivers coffee.

•

The cappuccino is now ready. Sweeten to taste and, if de-
sired, sprinkle the froth with a little cocoa powder.

NOTE 1: While making cappuccino, the flow of frothed milk or
coffee can be interrupted by pressing the

icon (B8).

NOTE 2: If the milk in the container finishes while delivering
frothed milk, remove the container and add milk.
Reattach and press the

icon (B8) to request a cappuccino

again.
NOTE 3: To ensure the complete cleanliness and hygiene of the
milk frother, always clean the circuits in the milk container lid
after making cappuccino. “PRESS CLEAN” flashes on the display.
•

Place a recipient under the milk spout (fig. 26).

•

Press the CLEAN button on the lid (C3) and hold down for at
least 5 seconds (fig. 26) to start the cleaning function.

The appliance displays the message “CLEANING UNDER-
WAY” above a progress bar. You should not release the
CLEAN button until the bar is complete indicating that
cleaning is concluded. When the CLEAN button is released,
the function stops. After cleaning, remove the milk contain-
er and place in the refrigerator. The milk should not be left
out of the refrigerator for more than 15 minutes.