V-ZUG Supremo HSL, Operating Instructions Manual, Page: 21 / 200

17
EN
Please note: If you encounter difficulty inserting the
infuser, before inserting it you must adapt it to the right dimen-
sion by pressing it forcefully from the bottom and top as shown
in the figure.
7. Once inserted, make sure the two yellow release buttons
have snapped out.
8. Replace the drip tray and grounds container.
9. Close the service door.
Cleaning the milk container
Important! Always clean the tubes inside the milk
container (C) when you prepare milk.
If there is still milk in the container, do not leave it out of the
refrigerator for longer than strictly necessary.
Clean the container each time you prepare milk as described in
Note 3 in the section “Making cappuccino”.
All components are dishwasher safe, placing them in the top
basket of the dishwasher.
1. Turn the lid of the milk container clockwise then remove it.
2. Remove the milk spout and intake tube.
spout
milk intake tube
3. Remove the froth regulator by pulling it outwards.
4. Wash all the components thoroughly with hot water and
mild washing-up liquid.
Make sure there are no milk residues left inside the holes
and the groove on the fine end of the froth regulator.
5. Check that the intake tube and spout are not clogged with
milk residues.
6. Replace the froth regulator, milk spout and intake tube.
7. Replace the milk container lid.
groove
froth regulator
hole hole
MENU SETTINGS
When you access the settings menu by pressing the icon
(B7) (fig. 15), the following menu items are available: Rinsing,
Set language, Energy saving, Set time, Auto start, Auto off, Set
temperature, Water hardness, Contrast,
Statistics, Default values,
Descale.
Rinsing
This function enables you to obtain hotter coffee.
Proceed as follows:
•
When you turn the appliance on, if you want to make a
small cup of coffee (less than 60 ml), preheat the cup by
rinsing it with hot water.
• If on the other hand more than 2/3 minutes have passed
since the last coffee was made, before requesting another
coffee, you must preheat the infuser by first pressing the
icon (B7) to enter the menu then the and
icons (B5 and B6) to select the “RINSING” function.
Press the icon (B4). “RINSING PRESS ” is displayed.
Press the icon (B4) again.
Deliver the water into the underlying drip tray or alterna-
tively use this water to fill (and then empty) the cup to be
used for the coffee to preheat it.
Set language
To modify the language of the display, proceed as follows: