4-16
TM-403 User’s Guide
Configure HMI Settings
D292105.7b.fm
The sealer’s inside and outside
seals are independently
adjustable. If one of the seals
needs to be moved, loosen the
corresponding position lock and
turn the adjusters.
Turning the wheel counter-
clockwise will move the guide
towards the operator. Turning it
clockwise will move the guide
closer to the machine. Adjust
the
Inner Seal Adjust
and the
Outer Seal Adjust
to the desired
position, then tighten the
Position Locks
to secure them.
Note:
See
Chapter 6: Trouble-
shooting
for sealer adjustment tips.
After the initial adjustment, run
the tape out again and observe
whether the cover tape aligns
itself satisfactorily. If it is still
misaligned, continue adjusting
the cover tape guide until it is
aligned properly.
5.
CREATE
TRAILER (optional)
The term “leader” and “trailer” refer to the lengths of empty carrier tape required at the
beginning (leader) and the end (trailer) of the finished reel of placed parts. Therefore,
when the reel is being taped on the TM-402, the trailer is the first length of empty carrier
tape run before the first part is taped and the leader is the length of empty carrier tape run
after the last part is taped.
a.
There are no HMI controls for creating a
Trailer
. If a
Trailer
is desired, simply open
the HMI
Taper Tab
and press
Continuous
Advance
at the beginning of the reel and
run out sealed empty pockets until the
desired trailer length is reached.
b.
Press the right
Arrow
key to move to the
next screen and configure leader creation.
Inner Seal Adjust
Outer Seal Adjust
Position Locks
Step 6:
Setup HMI
TAPER
