6-4
TM-403 User’s Guide
Preparing to Run a Pre-programmed Job
D292105.8b.fm
Preparing to Run a Pre-programmed Job
The initial set-up and configuration of a new job are covered in
Chapter 4: Setup
. This
chapter discusses the procedure for setting up existing jobs, running a job and routine
operator tasks.
Caution:
Users should always wear protective eye wear when operating
or maintaining the TM-402.
Power up the System
1.
Power up the machine by turning the
Main Power Switch
, which is
located on the right side of the machine, to the
ON
position.
2.
Press the blue
Reset
button on the left side of the machine.
Home Motors
Note:
The TM-402 only needs to be homed once after each power up or emer-
gency stop. Once the motors have been homed, they remain homed until the
machine is powered down.
1.
The HMI will open to the
Job Tab
with a red
Home Required
button at the top of
the
Tab Menu
and the other tab buttons grayed out. Press
Home Required
to
open the
Homing Status
window.
Step 1:
Power
Up
Step 2:
Home
Motors
