D292105.7b.fm
Taper Setup
Chapter 4: Setup
4- 9
Taper Setup
Loading Tape
The
Taper
must be loaded with carrier and cover tapes and configured for operation.
Begin by preparing the
Taper
, then move to the HMI to adjust settings. (
Step 7
)
Load Carrier Tape
1.
Check that the taper is set at the correct width for the carrier tape. If not, push or
pull the outer track in or out as needed, sliding it on the Detent Shafts until it is at
the required width.
3.
Once the track is adjusted, use a strip of the carrier tape as a test to determine if
the setting is correct. The carrier tape should slide through freely, but without
excess play back and forth. Tighten the set screws down again to secure the track
into place.
Step 5:
Setup
Taper
Step 5:
Setup
Taper
CARRIER
TAPE
Detent Shaft
Outer Track