4-2
TM-403 User’s Guide
Quick Start: Setup
D292105.7b.fm
Quick Start: Setup
The following is an outline of the basic steps required to setup the TM-402 for operation.
More detailed instructions follow in the next section of this chapter.
Caution:
Users should always wear protective eye wear when operat-
ing or maintaining the TM-402.
1.
Power up
• Power up the machine. Press
Reset
. Close all doors.
2.
Home the motors
• Press
Home Required
and
Home All Motors
.
3.
Load the Bowl Feeder
• Load components into the
Bowl Feeder
.
4.
Install Nozzle
• Ensure correct nozzle size and tip are installed.
5.
Load Taper
• Load carrier tape.
• Load cover tape.
• Place an empty reel on the
Take-up Arm
.
6.
Configure HMI settings
• Go to the
Job Tab
and run the
Job Wizard
to configure job settings.
7.
Test Sealer
• Perform a
Seal Tes
t to ensure a good seal, adjust
Sealer
settings as necessary.
8.
Setup 2D Vision
• Connect
• Setup
2D Vision
Inspection.
