5-4
TM-403 User’s Guide
Connect Vision
D292105.16c.fm
If the optional laptop was purchased for vision configuration V-
TEK, Inc. recommends users create a computer
Recovery
Disk
prior to operation and conduct periodic back-ups as
needed. Visit the computer manufacturer’s website for instruc-
tions on creating a recovery disk.
V-TEK, Inc. does not create or maintain recovery information for
this laptop. Creating a recovery disk is solely the users’
responsibility.
3.
Turn the computer on, then insert the Keyence IV-G software CD. When the
software installation screen appears, follow the prompts to install the Keyence
software.
Note:
Keyence IV-G Software is automatically installed if using the optional V-TEK
laptop or Keyence IV-G Monitor. If using one of these options, skip this step and
proceed to
Configure Inspection
.
4.
On the TM-402 HMI, select the
Taper Tab
, then press the
Right Arrow
key to
advance to the second Taper screen.
5.
Ensure the
Camera State
is
Enabled
. Ensure the
Parts Until Inspection
field is
correct.
Note:
The
Parts Until Inspection
value is the number of pockets between the
Place
point and the
Inspection
point. Begin the count at the
Place
position at zero,
so the
Place
position is not included.
Step 1:
Vision
Setup
CONNECT
