ChefTop
™
English
The digital control panel used in ChefTop™ ovens is designed to offer a straightforward interface between the oven and
the user. The control panel has been set up to alert you to possible error messages of the oven and accessories attached
to the oven.
Warning messages (caution):
When a malfunction is detected which allows the appliance to continue operating, abeit in a limited manner, a WARNING
message is displayed. The device continues to run and the WARNING message remains on the display until the
button is pressed.
Display
Description
Effect
Possible solution
WM01
Motor speed sensor warning
Motor breaking features disactivated
Consult a qualified technician for
repair
WM02
High temperature on the holding cabinet card
Risk to damage the holding cabinet card
Consult a qualified technician for
repair
WM03
Error on the core probe datas
It is not possible to set cooking step or start
programs that use the core probe
Consult a qualified technician for
repair
WM10
Detection of error in the power board non-essential
parameters
The holding cabinet continues to work
Consult a qualified technician for
repair
Alarm messages: (allarm):
When a condition arises which prevents the appliance from operating at all, an ALARM signal is displayed and the
appliance must be switched to its STOP status. The device stops operating and the ALARM! message appears
on the oven display until the problem is resolved. If the device is operating when the ALARM status occurs, it
will shut down and the alert corresponding to the detected problem will be displayed. To resolve a problem of
this type, contact an Authorised Assistance Centre. Once the problem has been resolved, the appliance can be
reactivated by pressing the «START/STOP» button.
If any other devices/accessories are connected to the oven, these will continue to operate normally unless the
alarm corresponds to a specific device that prevents its continued operation.
Display
Description
Effect
Possible solution
AM01
Holding Cabinet chamber
temperature alarm
Holding cabinet STOP
Consult a qualified technician for repair
AM02
Loss of communication between
holding cabinet and oven
Holding cabinet STOP
Consult a qualified technician for repair
AM10
Safety thermostat alam
Holding cabinet STOP
Consult a qualified technician for repair
AM10
E’ stato rilevato un errore in qualche
parametro indispensabili della scheda
mantenitore
Holding cabinet STOP
Consult a qualified technician for repair
N.B.
Every time the oven is started electrically, and every time the control P.C.B. exits STANDBY mode, the
control P.C.B. is scanned for ALARM / WARNING conditions (which appear on the display, about the oven
and all the connected equipment as well, if present).
23
Oven-user Communication
