Uniden UBCD436-PT, Owner'S Manual

Page: 22 / 108

12
Mounting Using the DIN-E Sleeve
If you are unsure about how to install your scanner in your vehicle using the optional DIN-E
sleeve, consult your automobile manufacturer, dealer, or a qualified installer. Before installing,
confirm that your scanner fits in the desired mounting area and you have all the necessary
materials to complete the task.
Your scanner requires a 2 x 7-1/8 x 5-5/16 inch (50 x 180 x 135 mm) mounting area. Allow an
additional 2-3/8 inch (60mm) space behind the unit for connectors and wires.
1.
Remove the bracket if it is attached.
2. Remove the four Philips screws from four small tabs on the rear of the case that secure the
outer metal case and pull off the case (toward the rear) with care.
3. Install the DIN sleeve into the opening in your dashboard, lip facing out.
4. Push out the top and bottom tabs to hold the sleeve firmly in place.
5. Before inserting the scanner in the sleeve, attach the cable from the previously mounted
antenna. Attach the DC Power leads. RED goes to a positive (+) connection on your fuse
block while BLACK connects to the vehicles chassis ground (-).
6. Connect the ORANGE lead to one side of the headlamp switch so that when you activate
the headlights, the scanners LCD display changes intensity. Be sure all the connections are
routed away from any potentially pinching or slicing sheet metal.
7. Slowly slide the scanner into the sleeve until it locks in place.
8. To remove the unit, fully insert the removal keys into each slot on the left and right edges of
the front panel. Carefully slide the radio from the sleeve.