Ultraframe Classic roof, Installation Manual

Page: 20 / 52

20
Fit the “L” shape PVC bracket to the
underside of the radius end. Offer up the
internal radius end to check the position of
the bracket before tightening.
To fit the internal radius end capping insert
the rose fixing button and tap the plastic
rivet home to secure the button. On some
occasions it may be preferable to test fit
the ridge internal cladding prior to fitting the
radius end capping.
GEORGIAN INSTALLATION
Screw the flashing trim to the ridge top
cap through the screw port. Use a 4.2mm x
13mm self drilling screw (not supplied).
59
Apply a generous amount of sealant to the
back edge of the flashing trim.
60
Offer up the complete ridge capping onto
the roof.
61
From the inside of the conservatory insert
the snap off tommy bar into the T bolt
62
Twist through 90° to locate the T bolt into
the ridge capping.
63
Pull down on the T bolt and tap the fixing
wedge into place to secure the T bolt. Cut
off the excess T bolt below the fixing wedge.
64
It is at this stage that the remaining
stepped flashings and saddle trim are
fitted
SEE PAGE 44
T Bolt
Tommy bar
SECTION 4
65 66
The internal radius end capping may
require trimming to suit pitch (pitch lines
are marked on the reverse of the internal
radius end capping).
15°
20°
25°
30°
FIT CONSERVAFLASH