Ultraframe Classic roof, Installation Manual

Page: 17 / 52

17
GEORGIAN INSTALLATION
Slide the complete assembly down the
glazing bar, using the endcap fixing block
as the ‘stop’.
39
Tease the ‘tail’ of the glazing support trim
tape free (ready to be pulled away when the
sealed unit is finally in position).
40
Centralise the glazing between the glazing
bars. If necessary pack it out on each side -
press it down onto the support trim.
41
SECTION 4
The rain baffle should nestle neatly to form
a continuous weather tight joint.
34
For each glazing bar, ‘snip’ two small cuts in
the weathering shield and then a horizontal
cut to remove ‘flap’ which facilitates the top
cap sliding under.
35 36
Now take the glazing end profile and run
continuous bead of sealant (appropriate
for glazing) immediately behind the co-
extruded gasket (along the full length).
Now seal the space between the glazing
end profile and the sealed unit (see inset)
at each end (DO NOT DO THIS ON POLY
ROOFS).
37
Snap off appropriate handed clip (left hand illustrated). Handing marked on base of clip.
Line up the rounded edge on base plate next to central web of glazing bar then tuck neatly
under gasket side of bar. Rotate clip into position. Push the grommet over the post as
shown.
38a 38b
Now glaze the side
frames before glazing
the roof - this provides
additional rigidity whilst
working above. INSTALL
TIE BARS(S) BEFORE
GLAZING.
NOT ON POLY