Ultraframe Classic roof, Installation Manual

Page: 12 / 52

12
GEORGIAN INSTALLATION
7
Fit the pre-formed soaker trim to each
starter bar (if pre-ordered). Temporarily
support the ridge and offer up the starter
bars, loosely attaching using the roofing
nuts and bolts supplied. THE SOAKER
ALLOWS CONSERVAFLASH OR CODE
4 LEAD TO BE DRESSED BEHIND THE
STARTER BAR TOP CAPPING.
Ensure the rain baffle upper leg is lifted
prior to placing the glazing bars that fit
to the ridge body sides. For 24mm glass
units/25mm poly, always set rain baffle into
its highest position.
8
10
Continue to support the ridge and offer up
the transom glazing bars (above), loosely
attaching using the roofing nuts and bolts
supplied. Ensure the rain baffle upper leg is
lifted prior to placing the glazing bars.
Offer up the hip bars.
11 12
13
Using Speedlok on the glazing bar end,
offer the ‘ball’ into the matching socket.
Attach bar at eaves position. Using your
thumb push down the upper dead lock so
it’s flush. YOU MUST NOT PUSH UP THE
LOWER WEDGE LOCK UNTIL STEP 31.
To remove the bar, lever up the dead lock
using a flat blade screwdriver, then insert
the screwdriver to release the socket latch.
See p20-21.
Next, attach the speedlok hood over each
bar, sliding it under the co-extruded gasket
of the glazing bar undercladding.
14
Pre-formed soaker Stepped flashings (L & R)
Saddle apron Horizontal flashing
To be used on duo-pitch roofs
To be used on lean-to & Ultralite & above
the saddle apron on duo-pitch roofs
To be used on duo-pitch roofs To be used on duo-pitch roofs
SECTION 4
Tighten the glazing bars first at the ridge
and then at the bottom (i.e. eaves beam).
9
Push down to locate, with the final position
abutting the front edge of the die cast end.
15