Ultraframe Classic roof, Installation Manual

Page: 18 / 52

18
GEORGIAN INSTALLATION
Ensure the glazing end profile sits snugly
behind the grommet. Now, using the fixing
provided screw down into the bar as shown.
Ensure clip offers maximum support to
glazing at all times.
If you are installing a roof vent please
refer to page 45.
42
Ensure the rain baffle upper leg is lifted pri -
or to fitting the top cappings.
43
Knock the glazing bar top cappings on
with a Deadblow hammer. Greater care
is needed in cold weather. Keep all trims
wrapped until they are needed. Once again
each capping is numbered according to its
position in the roof.
Work your way around the roof. The top cap
must be lifted into its final resting place (at
the ridge) prior to being knocked down over
the Anchor clip.
44
If you haven’t fitted already, attach end cap
fixing blocks - These arrive attached to the
end caps.Fit the glazing bar end caps by
sliding onto the fixing blocks. Push fit the
insert into the end cap.
45
Seal around the notched Georgian top cap
ready to receive the jack rafter capping.
46
SECTION 4
Ensure the jack rafter top capping is lined
up correctly (as above) before knocking the
top cappings into position. It is not possible
to ‘tap up’ the jack rafter top caps into final
position when fitted with anchor clips.
47
The jack rafter top capping should sit tightly
up to the hip bar top capping as shown.
48
Seal around the joint on the jack rafter
capping when complete.
49