Ultraflux Uf 841, User Manual

Page: 33 / 105

33
NT UF 841 CP GB (d) / June 2015
After choosing a suitable coupling medium, spread it lightly around the locations chosen for installing the
probes and copiously on the probes themselves.
3) Installing the probe
Attach the probes onto the pipe using straps or a dedicated support. Check the presence and continuity of
the coupling medium (ensure no air layer forms between the pipe wall and the probe). To avoid this pitfall,
refrain from sliding the probes too much (the coupling medium film could be altered/broken).
4.4.3. Inserted probes
Preliminary comment : before you do anything, you must check with Ultraflux whether your probes can be
extracted under load or not. Whether an inserted probe may be extracted under load or not is determined
by the probe used and the application conditions of your measuring point (pressure, fluid measured, etc.).
1) Flanged probes
1
st
step: Check the position of the bosses relative to the drawing provided by Ultraflux
2
nd
step: Check the state of the seal face which must be free of irregularities and dirt. Seal faces which are
rusted, battered or generally in a bad state of repair must not be used.
3
rd
step: Insert the probe into the boss making sure the seal is present.
4
th
step: Insert the probe fixing screws and tighten them to the recommended tightening torques.
5
th
step: Connect the probes to the flow meter through the connecting head.