Ultraflux Uf 841, User Manual

Page: 22 / 105

22
NT UF 841 CP GB (d) / June 2015
3.6.2 Ultrasonic chords
Unsheath a length of cable of between 10 and 15mm and bend
back the ground braiding as shown opposite. Next, strip a length of
about 5 mm of the conductors. Whilst doing this, note the colour
difference of the two conductors: on the Twinax cable, the one is a
galvanised colour and the other copper-coloured.
Cover the ground braiding with copper tape to prevent the threads
of the ground from becoming loose and thus causing short-circuits.
After passing it through the cable gland of your choice, connect the
probe cable to the terminal board (disconnect the machine if this
makes the operation easier), taking care always to connect the
copper-coloured conductor on the same side on the terminals.
Connect the terminals to suitable positions, then place the shield
connection jumper.
Only tighten the knurled nuts at the end, ensuring the shield
connection jumpers are correctly secured, avoiding pressure
exertion on the contact plates placed below these jumpers.